Foxflash Read and Write Nissan EDC71C84 on Bench and Boot


Is it possible to read and write EDC17C84 NISSAN MICRA with foxflash via OBD?

No, just bench and boot.

 

Read Nissan EDC17C84 with foxflash on bench

BOSCH EDC17 C84 [ 1782 ] – Renault, Nissan [Diesel]

Connect the multifunction cable as follows

Read Nissan EDC17C84 with foxflash on bench 1

To read and write use the following driver:
→ BENCH TRICORE
→ RENAULT or NISSAN
→ TC1782 – RENAULT
→ EDC17 C84

ATTENTION:
Some EDC17C84 enter in Bench mode with the white and brown wires on pins F4 and G4. If with the previous pinout doesn’t enter in bench tricore mode, then try again by connecting it as follows:

Read Nissan EDC17C84 with foxflash on bench 2

Read Nissan EDC17C84 with fox flash in boot mode

BOSCH EDC17 C84 [ TC1782 INT.F.] – Renault, Nissan

Step 1: Password search

Connect the pinout below with multifunction cable.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ PASSWORD BFT
→ Click on “Find Password” and follow the software messages.

Read Nissan EDC17C84 with foxflash in boot 1

If the password was found with this system, go directly to the boot step to read and write the control unit.
Otherwise, try again with the driver PASSWORD BFT connecting the white and violet wires on the pcb:

Read Nissan EDC17C84 with foxflash in boot 2

Now that the password has been found it’s possible to read and write the control unit. See next step.

Step 2: Read and Write ECU

Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1782

Read Nissan EDC17C84 with foxflash in boot 3